Trex600 Tail pulley

[eheliman]

Hi everyone,

Did anyone use the Metal Tail Rotor Shaft Assembly H60079 for Trex 600?
I want to know how the shaft put inside the aliminium pulley. Can I take it out? Thanks!

[G-MRM]

I think it is a press fit with loctite, can I ask why you want to remove it ? The bearings fit onto each side and the case then fits both sides so no need to pull it off, you don't want it to come loose when flying !! :roll:

[eheliman]

I don't want to pull it out, but I want to know how it is fixed and see it drives safely or not.

[G-MRM]

I would hope it is fixed well, I would not want to remove it to test, I think the metal is too thin to drill and tap for a fixing screw! Maybe drill a small hole for a drive pin for peace of mind?